As per previous posts, blog’s etc.
This press has been discontinued by
Lee in April 2022. The tooling for this press has reached end of life.
Lee said that they will keep spares
for 5 years but will not be able to produce more.
Some spares have become difficult or
impossible to find.
While Lee still shows stock we have
not had any of these available in SA for a while.
LM3238 – Carrier
LM3232 – Yoke Clamp
LM3236 – Yoke
The following is not available
anymore from Lee.
PRIMER WEDGE BAR with SCREW · LM3261
RAM · LM3237
5 HOLE TURRET · 90079 (Still have
stock in SA)
90907 – Shell Plate 1 – 38spl/357mag
To keep your press running as long
as possible follow these tips:
Lube your cases, even when using
carbide dies. This will prevent strain on the carrier.
Keep your press clean and well
lubed.
Do not force the press!
Make sure of your die setup. Dies
set too deep will damage the carrier!
Do not overtighten the carrier on
the draw bolt! It must just snug on the teeth of the ram. If you do overtighten
the carrier you will damage the center part of the carrier and your shell plate
will not rotate freely. You will also damage your Yoke and Yoke Clamp.
If the Yoke and Yoke Clamp is bent,
your carrier will not secure on the ram and will keep moving.
Be careful when buying second hand.
Think hard about outlaying cash for
a press that will be obsolete in a few years.
The Load Master has been replaced by
the Six Pack Pro.
The Six Pack Pro is a much better,
stronger and easier press to use.
Start saving up for one.
